Missing LAN Apapter

Have a question about Active Wall? Ask it here!

Missing LAN Apapter

Postby rsukraj » Fri Nov 16, 2007 11:13 am

Hello, I'm new to this app. I downloaded Traffic Monitor. After the installation I was promoted to "select internal adapter and work mode". I went to configure the app to work in "Single" mode, but I cannot see any MAC addresses listed in the dialog box and the IP address is 0.0.0.0. I can't "Start Service"...keep getting the "Run for the first time, need to select internal adapter and work mode" message. I installed the app on WIN2K3 Server. Adapter is D-Link DFE-530TX+ PCI Fast Ethernet Adapter.

The app looks like a good one, I would like to start using it but need some assistance getting through this initial setup. Any help would be greately appreciated.

Thanks.

Regards,
Raul
rsukraj
 
Posts: 1
Joined: Fri Nov 16, 2007 11:06 am

Postby admin » Fri Nov 16, 2007 7:25 pm

Why do I read an empty network adapter list?
1.Please check whether the driver is normally installed, and check the network adapter connection properties.
2.Please check the [Active Capture Driver] option.
3.If there is no such [Active Capture Driver] option in the general tab, please uninstall the software and restart the system. And then install the software again. When it shows a warning dialog while installing the software, press <Continue anyway>.
4.If there is an option [Active Capture Driver] checked, please try to cancel the check and then check it again. When it shows a warning dialog while installing the software, press <Continue anyway>.
admin
Site Admin
 
Posts: 386
Joined: Wed Dec 31, 1969 4:00 pm


Return to Questions & Answers

Who is online

Users browsing this forum: No registered users and 1 guest

cron